Overview
Vaporesso pods come in several families that don’t swap between each other: XROS pods fit every XROS device, Luxe X pods fit the Luxe X, X Pro, X2 and X3, Luxe Q pods fit the Luxe Q and QS, and Vaporesso’s larger pod mods use separate GTX or GTi coils. Buying the wrong family is the most common pod mistake we see, because the names are so similar. This guide gives you a family-by-family chart, the resistances each pod comes in, and the exceptions worth knowing. Where Vaporesso publishes official compatibility, we link to it; where it doesn’t, we say so. Vaporesso devices and pods are for adults aged 18 and over only.
In this guide
XROS pods
XROS pods are the simplest case. Vaporesso states that every XROS pod fits every XROS device, from the original 2020 XROS through the XROS 2, 3, 4, 5, their Mini and Nano versions, the XROS Pro and Pro 2 and the XROS Cube (Vaporesso XROS pod compatibility chart). If you own any XROS, you can buy XROS pods with confidence.
XROS pods are refillable top-fill pods with a built-in mesh coil. Vaporesso lists the standard resistances as 0.6, 0.8, 1.0 and 1.2 Ω. It also lists a 0.4 Ω pod supported by the XROS Pro 2 for a looser draw. Standard pods hold 3 ml; regions following EU TPD rules get 2 ml versions that work the same way.
At Vape Store Web you can buy XROS replacement pods (2-pack, AED 25), XROS 3 pods (4-pack, AED 45) and the XROS series pod cartridge. Check the resistance on the pack before you order.
Vaporesso warns against third-party “XROS-compatible” pods, which may fit but seal less reliably. Genuine pods cost a little more and are far less likely to leak.
Luxe X and Luxe XR pods
The Luxe X family uses larger 5 ml pods (2 ml in TPD regions) with a bottom-fill design and built-in coils. Vaporesso lists its current Luxe X pod as compatible with the Luxe X, X2 and X3, and notes that it also works with earlier devices such as the Luxe X Pro (Vaporesso Luxe X pod).
Luxe X pods come in several resistances, from about 0.3 Ω for direct-to-lung clouds, through 0.4 and 0.6 Ω for restricted lung hits, to 0.8 Ω for a mouth-to-lung draw. That range is what lets one Luxe X device handle different vaping styles.
The Luxe XR and XR Max are slightly different. They use Luxe XR pods, which take separate, replaceable GTX mesh coils instead of a built-in coil. When the coil wears out, you replace just the coil, not the pod. Several retailers describe Luxe X pods as fitting the XR-series devices too, but Vaporesso’s current Luxe X pod page doesn’t list them, so if you own an XR, the safest choice is Luxe XR pods with GTX coils.
We stock Luxe X series 5ml pods and Luxe X replacement pods. Our Vaporesso Luxe series comparison explains the devices themselves.
Luxe Q pods
The Luxe Q family uses small 2 ml or 3 ml refillable pods with built-in mesh coils, in 0.6, 0.8, 1.0 and 1.2 Ω. Vaporesso lists Luxe Q pods as compatible with the Luxe Q and Luxe QS (Vaporesso Luxe Q pods).
There’s an important exception. Vaporesso notes that the 3 ml Luxe Q pods are not compatible with the Luxe Q2 and Q2 SE, which need the 2 ml version. If you own a Q2 or Q2 SE, check the capacity on the pack, not just the “Luxe Q” name.
The newer Luxe Q3 uses a 3 ml side-fill pod. A retailer compatibility guide lists it as running Luxe Q-series pods and warns that Luxe X or XR pods are far too large for its pod slot. Vaporesso’s own Luxe Q pod page doesn’t yet list the Q3, so message us before buying spare pods for a Q3.
We stock Luxe Q pods (4-pack, AED 40), Luxe Q pods (AED 25) and Luxe QS pods (4-pack, AED 45). The Luxe QS pods come in 0.6 and 1.0 Ω.
ECO Nano, Zero, Vibe and Osmall pods
Vaporesso’s other pod lines each have their own cartridges. The ECO Nano uses a large 6 ml pod with a built-in COREX mesh coil in 0.8 or 1.2 Ω; we stock the ECO Nano pod cartridge. It’s designed for the ECO Nano and won’t fit XROS or Luxe devices.
The Zero 2 uses 3 ml press-to-fill pods (Zero 2 pods), and our listing for Zero S pods describes them as compatible with Zero and Zero 2 devices. The older Renova Zero takes its own Renova Zero pods.
The Vibe family and the Osmall 2 also have dedicated pods: the Vibe refillable pod cartridge and the Osmall 2 replacement pods, which fit the Osmall 2 and original Osmall.
For all of these, the device name on the pack is the thing to match. If the name doesn’t match your device exactly, ask us before ordering; it takes a minute on WhatsApp.
GTX and GTi coils for pod mods
Vaporesso’s larger pod mods don’t use built-in-coil pods. Instead they use a refillable pod or tank with a separate, replaceable coil. There are two main coil families. GTX mesh coils are used in devices such as the Luxe XR and XR Max, the Armour G series and the GEN SE. GTi mesh coils are used in the iTank 2 and devices such as the GEN 200 and Target 100.
GTX coils come in a wide spread of resistances. Our listing shows 0.2 Ω (45–60 W), 0.3 Ω (32–45 W), 0.4 Ω (26–32 W), 0.6 Ω (20–26 W), 0.8 Ω (12–20 W) and 1.2 Ω (8–12 W). Low-ohm coils suit direct-to-lung clouds; 0.8 and 1.2 Ω suit mouth-to-lung.
GTX and GTi coils are not interchangeable, and neither fits built-in-coil pods such as XROS or Luxe X. Buy GTX coils (5-pack) or GTi coils (5-pack) according to your device.
Replaceable coils usually cost less over time than replacing whole pods, which is one reason heavier vapers move to a pod mod.
Vaporesso pods compatibility chart
Use this chart as a quick reference for Vaporesso pods. Match the family, then choose the resistance for your vaping style.
| Your device | Pod / coil to buy | Resistances | Source |
|---|---|---|---|
| Any XROS (1–6, Mini, Nano, Pro, Cube) | XROS pods | 0.6 / 0.8 / 1.0 / 1.2 Ω (0.4 on Pro 2) | Vaporesso |
| Luxe X, X Pro, X2, X3 | Luxe X pods | 0.3–0.8 Ω | Vaporesso |
| Luxe XR, XR Max | Luxe XR pods + GTX coils | GTX 0.2–1.2 Ω | Our listings |
| Luxe Q, QS | Luxe Q pods | 0.6 / 0.8 / 1.0 / 1.2 Ω | Vaporesso |
| Luxe Q2, Q2 SE | 2 ml Luxe Q pods only | As above | Vaporesso |
| Luxe Q3 | Ask us first | — | Not yet listed by Vaporesso |
| ECO Nano | ECO Nano pods | 0.8 / 1.2 Ω | Our listing |
| Armour G series, GEN SE | GTX coils | 0.2–1.2 Ω | Our listings |
| GEN 200, Target 100, iTank 2 | GTi coils | Mesh, e.g. 0.2 / 0.4 Ω | Our listings |
Choosing a pod resistance
Once you know the family, the resistance decides how the vape feels. Higher resistance (1.0–1.2 Ω) gives a tighter, cooler mouth-to-lung draw that suits 20 mg salt-nicotine e-liquid. Mid resistance (0.6–0.8 Ω) gives a warmer, slightly looser draw with more vapour, and is the most popular all-rounder.
Low resistance (0.3–0.4 Ω) is for restricted or full direct-to-lung vaping with bigger clouds. At these resistances, use low-strength freebase e-liquid rather than 20 mg salt nic, which would feel harsh. Our guides to freebase vs salt nic and e-liquid nicotine strength explain why.
Pod life depends on the e-liquid and how much you vape. Sweet, dark e-liquids clog coils faster, so expect fewer days per pod with dessert flavours than with menthol or fruit. Priming a new pod (filling it and waiting a few minutes before the first puff) helps prevent a burnt first hit.
Store spare pods sealed, and keep your device out of hot cars and direct sun, which is hard on both pods and batteries in UAE summer heat. For devices, see our Vaporesso brand page.
Do all Vaporesso pods fit all Vaporesso devices?
No. XROS, Luxe X, Luxe Q, ECO Nano and other lines each use their own pods. Only XROS pods are universal across their whole family.
Will XROS pods fit a Luxe device?
No. XROS pods only fit XROS devices. Luxe X and Luxe Q devices use their own pods.
How long does a Vaporesso pod last?
Typically several days to a couple of weeks, depending on how much you vape and the e-liquid. Replace it when the taste turns burnt or flat.
Where can I buy genuine Vaporesso pods in Dubai?
Vape Store Web stocks genuine Vaporesso pods and coils with delivery within 2 hours in Dubai and 24 hours across the UAE.